This photo shows the soldered connections made to the light. Make sure that you do a solid solder connection and insulate the exposed connections with shrink tube. Note the switch is a simple in-line toggle. If the light burns out, you need to re-solder in a new light bulb.
This photo shows the bulb and switch ready to go into the housing. Basically just stuff it all back into the housing. The fit is tight, but it will fit. If solid solder connections were made and the connections were properly insulated, then you will have no problems at all.
2 comments:
hi mate are you running a fuse after the switch. i have a sumlier set up and cant turn off the light the wires get hot
very interesting, thanks
Post a Comment